Description
A Top Quality Heater matrix to fit the Toyota Optimo Minibus 1996 onwards
Heater matrix blocked and giving out no heat?
Then you need to read this before you buy a new one.
The original heater for your vehicle was made from aluminium with very narrow water tubes, as you can see in the listing picture above. Â Original equipment and cheap, poor quality imported replacements all use this design which blocks up very quickly, easily leaving you with no heat.
Our tried and tested copper and brass design has wider water tubes which allow any small particles to flow freely and not block the heater.
Fitting a replacement heater matrix is a very costly labour-intensive job so it makes sense to fit one that won’t block up again.
There will always be someone who says that they can ”do it cheaper” – but at what cost?
Buy cheap – Buy twice!
This is a copper and brass version of an aluminium original heater matrix made to the highest standards in the UK. The original pipes are re-used and fitted to the new unit using a set of clamps and seals which are supplied. The original heater has a shaped top tank, but our fittings are attached to mitred pipes on a flat tank, this will not affect fitting or function and the heater is a direct replacement. You can click on the image to enlarge it or move your cursor over a specific area to look more closely at a particular feature on the heater core. The dimensions given below are at the longest, widest and deepest points of the heater and not the centre core measurements. If you are not sure whether this is the heater you require please contact us and we will help.
If the stock shows zero we may still be able to help so please contact us
We specialise in manufacturing heaters to a sample so if you can’t find the heater matrix for your vehicle please contact us
Only logged in customers who have purchased this product may leave a review.